Outside Of Hull Is Finished

Over the last few days the woodwork on the outside of the hull has been completed. Before I turn the boat over to work on the inside of the hull I am going to paint the outside. This will take quite a while because there is a lot to do before the painting starts. All the excess epoxy has to be cleaned off, all the sharp corners have to be rounded off, all the inside corners will have a fillet of thicked epoxy added and the whole has to be sanded and sanded and sanded!

With the sheer plank doublers in place, see the previous post, the rubbing strip and outer gunwale could be added. I did the rubbing strip first and made the mistake of putting the strips down the side of the hull first. This was a mistake because it made fitting the matching strip across the transom much harder as it had to fit exactly between the side strips. Not only that but it was curved and so had to be laminated in place. Here's the result (note that I am talking about the top strip without the clamps). There are three laminations, each had to be sprung into place  and then cut to length. Once fitted they were coated with glue and sprung back into position and then clamped. All very tricky and sticky!





 

Having made that mistake I added the strip to the transom to match the outer gunwale before the side pieces. I was able to apply more force to bend this one and made it in two laminations. Once the glue set I trimmed the ends of the strip flush with the sheer plank and put the outer gunwales in place. Here are some photos of the hull with all these pieces in place.

 

 

 

As I said, next job is to clean off the excess epoxy which is clearly visible in the photo above. Before I start on that though I am going to take my trailer sailer out for a couple of weeks sailing in the Great Sandy Strait. It will be sunny and hot but I am hoping for enough breeze to keep things reasonably cool and to keep the sand flies at bay!